Margin calls are mechanisms put in place by your Forex broker in order to keep your used margin secure. Remember, your used margin is allocated by your broker as the collateral for funds borrowed from your broker. A margin call happens when your free margin falls to zero, and all you have left in your trading account is your used, or required margin. When this happens, your broker will automatically close all open positions at current market rates.
There is one unpleasant fact for you to take into consideration about the margin call Forex. You might not even receive the margin call before your positions are liquidated. If the money in your account falls under the margin requirements, your broker will close some or all positions, as we have specified earlier in this article. This can actually help prevent your account from falling into a negative balance.
Risk Management - Many "research" backtests completely ignore risk management. Unfortunately this is generally necessary for brevity in describing the rules of a strategy. In reality we -must- use a risk overlay when trading, otherwise it is extremely likely that we will suffer a substantial loss at some stage. This is not to say that risk management can prevent this entirely, but it certainly makes it less likely!

Often, closing one losing position will take the margin level Forex higher than 5%, as it will release the margin of that position, so the total used margin will decrease and consequently the margin level will increase. The system often takes the margin level higher than 5%, by closing the biggest position first. If your other losing positions continue losing and the margin level reaches 5% once more, the system will just close another losing position.
Retail or beginning traders often trade currency in micro lots, because one pip in a micro lot represents only a 10-cent move in the price. This makes losses easier to manage if a trade doesn't produce the intended results. In a mini lot, one pip equals $1 and that same one pip in a standard lot equals $10. Some currencies move as much as 100 pips or more in a single trading session making the potential losses to the small investor much more manageable by trading in micro or mini lots.

We also apply a concentrated margining requirement to Margin accounts. An account's two largest positions and their underlying derivatives will be re-valued using the worst case scenario within a +/- 30% scanning range. The remaining positions will be re-valued based upon a move of +/-5%. If the concentrated margining requirement exceeds that of the standard rules based margin required, then the newly calculated concentrated margin requirement will be applied to the account.
The majority of the volume in currency trading is confined to only 18 currency pairs compared to the thousands of stocks that are available in the global equity markets. Although there are other traded pairs outside of the 18, the eight currencies most often traded are the U.S. dollar (USD), Canadian dollar (CAD), euro (EUR), British pound (GBP), Swiss franc (CHF), New Zealand dollar (NZD), Australian dollar (AUD) and the Japanese yen (JPY). Although nobody would say that currency trading is easy, having far fewer trading options makes trade and portfolio management an easier task.
Now, let’s say you open a trade worth $50,000 with the same trading account size and leverage ratio. Your required margin for this trade would be $500 (1% of your position size), and your free margin would now also amount to $500. In other words, you could withstand a negative price fluctuation of $500 until your free margin falls to zero and causes a margin call. Your position size of $50,000 could only fall to $49,500 – this would be the largest loss your trading account could withstand.
We also apply a concentrated margining requirement to Margin accounts. An account's two largest positions and their underlying derivatives will be re-valued using the worst case scenario within a +/- 30% scanning range. The remaining positions will be re-valued based upon a move of +/-5%. If the concentrated margining requirement exceeds that of the standard rules based margin required, then the newly calculated concentrated margin requirement will be applied to the account.
Foreign exchange (forex) or FX trading involves trading the prices of global currencies, and at City Index it is possible to trade on the prices of a huge range of global currencies. Currency trading allows you to speculate on the movement of one currency against another, and is traded in pairs, for example the Euro against the US Dollar (EUR/USD).
If you sell a security short, you must have sufficient equity in your account to cover any fees associated with borrowing the security. If you borrow the security through us, we will borrow the security on your behalf and your account must have sufficient collateral to cover the margin requirements of the short sale. To cover administrative fees and stock borrowing fees, we must post 102% of the value of the security borrowed as collateral with the lender. In instances in which the security shorted is hard to borrow, borrowing fees charged by the lender may be so high (greater than the interest earned) that the short seller must pay additional interest for the privilege of borrowing a security. Customers may view the indicative short stock interest rates for a specific stock through the Short Stock (SLB) Availability tool located in the Tools section of their Account Management page. For more information concerning shorting stocks and associated fees, visit our Stock Shorting page.
For those of you who are new to source version control you will probably want to read up on how git (and version control in general) works with the fantastic free ebook Pro Git. It is worth spending some time learning about source control as it will save you a huge amount of future headache if you spend a lot of time programming and updating projects!
Now that we have discussed the longer term plan I want to present some of the changes I have made to the code since diary entry #2. In particular, I want to describe how I modified the code to handle the Decimal data-type instead of using floating point storage. This is an extremely important change as floating point representations are a substantial source of long-term error in portfolio and order management systems.
Free Margin – Your free margin represents your total equity minus any margin used for leveraged trades. For example, if your equity is $1,000 and your used margin is $100, your free margin would amount to $900. Following your free margin is extremely important, as it is used to withstand negative price fluctuations from your open trades and to open new leveraged trades. It’s important to understand that your free margin increases with profitable positions, but decreases with your losing positions. Once the free margin drops to zero or below, your broker will activate the so-called margin call and close all your open positions at the current market rate, in order to prevent your equity from falling below the required margin.
Maintenance margin for commodities is the amount that you must maintain in your account to support the futures contract and represents the lowest level to which your account can drop before you must deposit additional funds. Commodities positions are marked to market daily, with your account adjusted for any profit or loss that occurs. Because the price of underlying commodities fluctuates, it is possible that the value of the commodity may decline to the point at which your account balance falls below the required maintenance margin. If this happens, brokers typically make a margin call, which means you must deposit additional funds to meet the margin requirement.
Margin requirements for futures and futures options are established by each exchange through a calculation algorithm known as SPAN margining. SPAN (Standard Portfolio Analysis of Risk) evaluates overall portfolio risk by calculating the worst possible loss that a portfolio of derivative and physical instruments might reasonably incur over a specified time period (typically one trading day.) This is done by computing the gains and losses that the portfolio would incur under different market conditions. The most important part of the SPAN methodology is the SPAN risk array, a set of numeric values that indicate how a particular contract will gain or lose value under various conditions. Each condition is called a risk scenario. The numeric value for each risk scenario represents the gain or loss that that particular contract will experience for a particular combination of price (or underlying price) change, volatility change, and decrease in time to expiration.
Whether you have assets in a securities account or in a futures account, your assets are protected by U.S. federal regulations governing how brokers must protect your property and funds. In the securities account, your assets are protected by SEC and SIPC rules. In the futures account, your assets are protected by CFTC rules requiring segregation of customer funds. You are also protected by our strong financial position and our conservative risk management philosophy. See our Strength & Security page.
Borrowing money to purchase securities is known as "buying on margin". When an investor borrows money from his broker to buy a stock, he must open a margin account with his broker, sign a related agreement and abide by the broker's margin requirements. The loan in the account is collateralized by investor's securities and cash. If the value of the stock drops too much, the investor must deposit more cash in his account, or sell a portion of the stock.
Retail or beginning traders often trade currency in micro lots, because one pip in a micro lot represents only a 10-cent move in the price. This makes losses easier to manage if a trade doesn't produce the intended results. In a mini lot, one pip equals $1 and that same one pip in a standard lot equals $10. Some currencies move as much as 100 pips or more in a single trading session making the potential losses to the small investor much more manageable by trading in micro or mini lots.
To date, we've been experimenting with the OANDA Rest API in order to see how it compared to the API provided by Interactive Brokers. We've also seen how to add in a basic portfolio replication element as the first step towards a proper event-driven backtesting system. I've also had some helpful comments on both previous articles (#1 and #2), which suggests that many of you are keen on changing and extending the code yourselves.
Often, closing one losing position will take the margin level Forex higher than 5%, as it will release the margin of that position, so the total used margin will decrease and consequently the margin level will increase. The system often takes the margin level higher than 5%, by closing the biggest position first. If your other losing positions continue losing and the margin level reaches 5% once more, the system will just close another losing position.
It is essential that traders understand the margin close out rule specified by the broker in order to avoid the liquidation of current positions. When an account is placed on margin call, the account will need to be funded immediately to avoid the liquidation of current open positions. Brokers do this in order to bring the account equity back up to an acceptable level.
To get started, investors interested in trading in the forex markets must first sign up with either a regular broker or an online forex discount broker. Once an investor finds a proper broker, a margin account must be set up. A forex margin account is very similar to an equities margin account – the investor is taking a short-term loan from the broker. The loan is equal to the amount of leverage taken on by the investor.
As part of the Universal Account service, we are authorized to automatically transfer funds as necessary between your securities account and your futures account in order to satisfy margin requirements in either account. You can configure how you want us to handle the transfer of excess funds between accounts on the Excess Funds Sweep page in Account Management: you can choose to sweep funds to the securities account, to the futures account, or you can choose to not sweep excess funds at all.

In particular I've made the interface for beginning a new backtest a lot simpler by encapsulating a lot of the "boilerplate" code into a new Backtest class. I've also modified the system to be fully workable with multiple currency pairs. In this article I'll describe the new interface and show the usual Moving Average Crossover example on both GBP/USD and EUR/USD.
×